Product Categories
Roller Shutter Remote Control
RRP £59.00
£49.00 inc. tax

£40.83 ex. tax
? Tax based on United Kingdom.
Roller Shutter Remote Control Summary

Roller Shutter Remote Control


Part No.  RC1000

A roller shutter remote control system for use with roller shutter doors and roller garage doors that use a 230V ac tubular motor with built in limit switches.

Simple to install, connect 230V mains supply and the four wires from the motor.

Wiring diagram and instructions  RC1000 instructions download

  • High security 868.35 MHz rolling code radio remote control system
  • Low voltage Open and Close control inputs for connection of  push buttons, rocker or key switch, the Open input can be connected to a fire alarm control panel to open the door in case of fire 
  • Photocell safety beam input - only active when door is closing, if the beam is broken the door will stop and reverse, suitable safety beams are available from our store
  • 24V ac output to power the safety beam
  • Push to run or hold to run (dead man, man present) closing option, selectable by DIP switch
  • 230V courtesy light output that switches on for 3 minutes whenever the door is opened or closed
  • Separate Open, Close and Stop remote control handset buttons with sliding safety cover to prevent accidental activation
  • Also available is a five channel transmitter this allows up, down and stop control of up to 5 roller shutters either individually or simultaneously (group control)
  • Supplied with 2 remote control transmitters, additional transmitters are available
    The RC1000 operates on the new European permitted frequency of 868.35 MHz exclusively for use by remote controls it is not subject to interference from other radio signals such as wireless energy monitors, walkie-talkies, wireless alarm systems, wireless weather stations, etc
    Power supply 230V ac
    Maximum motor power 500W single phase
    Radio receiver 868.35 MHz , high security, rolling code, superhetrodyne
    Memory capacity 32 codes (transmitters)
    Control switch inputs OPEN and CLOSE
    Safety input / Photocell input Works when closing stops and reverses motor
    Auxiliary power output 24V ac, 100mA to power photocells
    Motor run time 60 seconds
    Motor fuse 6.3A delayed
    Dimensions 155 x 110 x 75 mm, transmitter 50 x 30 x 10 mm
    Protection IP56
    Product Condition:
    Customer Reviews
    (write review)
    rc1000 roller shutter control unit. not tried new metal hand controllers
    box well made.cut entry glands to suit cable sizes.cover seals well. circuit board well made. terminal screws would be better with a deeper screwdriver slot. receives ok at 50feet.hand controllers plastic WELL MADE .swapped cables to rc1000 from old unit,works ok. very good value
    Product Added to your Cart

    -------- OR --------