ROLLER SHUTTER & ROLLER GARAGE DOOR REMOTE CONTROL
Part No. RC1000
A roller shutter remote control system for use with roller shutter doors and roller garage doors that use a 230V ac tubular motor with built in limit switches.
Simple to install, connect 230V mains supply and the four wires from the motor.
- High security 868.35 MHz rolling code radio remote control system
- Low voltage Open and Close control inputs for connection of push buttons, rocker or key switch, the Open input can be connected to a fire alarm control panel to open the door in case of fire
- Photocell safety beam input - only active when door is closing, if the beam is broken the door will stop and reverse, suitable safety beams are available from our store
- 24V ac output to power the safety beam
- Push to run or hold to run (dead man, man present) closing option, selectable by DIP switch
- 230V courtesy light output that switches on for 3 minutes whenever the door is opened or closed
- Separate Open, Close and Stop remote control handset buttons with sliding safety cover to prevent accidental activation
- Also available is a five channel transmitter this allows up, down and stop control of up to 5 roller shutters either individually or simultaneously (group control)
- Supplied with 2 remote control transmitters, additional transmitters are available
The RC1000 operates on the new European permitted frequency of 868.35 MHz exclusively for use by remote controls it is not subject to interference from other radio signals such as wireless energy monitors, walkie-talkies, wireless alarm systems, wireless weather stations, etc
|
SPECIFICATIONS
|
| Power supply |
230V ac |
| Maximum motor power |
500W single phase |
| Radio receiver |
868.35 MHz , high security, rolling code, superhetrodyne |
| Memory capacity |
32 codes (transmitters) |
| Control switch inputs |
OPEN and CLOSE |
| Safety input / Photocell input |
Works when closing stops and reverses motor |
| Auxiliary power output |
24V ac, 100mA to power photocells |
| Motor run time |
60 seconds |
| Motor fuse |
6.3A delayed |
| Dimensions |
155 x 110 x 75 mm, transmitter 50 x 30 x 10 mm |
| Protection |
IP56 |
